Care and Installation Instructions for your Softub - Softub Schweiz (2024)

With regular and thorough care of your Softub whirlpool you ensure a hygienic bathing experience and prevent damage to motor, tub and supply lines.

To care for your Softub whirlpool properly, please observe the following instructions and make use of the checklist on the reverse side.

Important remarks

• Mount and demount your filter only in a warm state and when the pump is in standby mode. Take off the filter sock before cleaning.
• If you close the pool with the cover, make sure you switch off the jets, means the lever must point in the direction of the light button
• After adding chemicals, air the tub for at least 30 minutes (take off cover completely). Ensure that the tub has access to enough oxygen, even when rarely used (air out regularly).
• Clean the rim of the tub (above the water line) regularly, and thoroughly rub it dry afterwards.

Filling tub

• Before filling, flush the hose thoroughly. Residues in the hose make for bad water.
• While filling, rub the inner film of the tub on the bottom flat from the middle towards the outside, so that no folds develop.
• Only plug the motor into the mains when the water level is above all the nozzles.

Emptying tub / water change

• Dissolve the cleaning tablet in warm water and add the liquid to the pool. Put on the cover and allow the cleaning product to work for up to 24h.
• Remove the filter while it is still warm, to prevent damage to your pool. Important: Avoid any pulling or twisting movements!
• Disconnect the motor from the mains and empty the pool with ideally a submersible pump.
• After removing the motor, set the tub on its side and spray it off thoroughly with water.

Storage and overwintering

• If your Softub whirlpool remains unused over winter, remove the motor, and store it in a frost-safe place.
• To remove the motor, unscrew the three clips (since 2017), pull the light cable out, and pull the motor to the back. Don’t make any back-and-forth movements and don’t hold the motor by the supply lines, to prevent them from becoming damaged.
• Thoroughly dry the tub and cover.
• With the help of a dehumidifier box, you can prevent the formation of mould in the tub.
• Do not store the tub on edge, this can lead to deformation.

Care information, cleaning products and helpful utensils

Below you will find the necessary care and cleaning products and instructions for correct use, to ensure your Softub whirlpool provides you with enjoyment for a long time!

In addition to the products listed, Softub Schweiz has helpful cleaning and care utensils, such as many different sponges, gloves and nets.

More helpful care products and cleaning utensils can be found in our Shop

PDF – Care and installation instructions

Filter chemicals, suspended matter and heavy metals with the Great Barrier filter.

Connect the water filter to the garden hose and slowly fill the pool.

The slower the water is filled, the softer it will be.

• 

  View Cart

  Add to cart/Details

  Great Barrier water purifier – removes heavy metals

  CHF49.00

Prevent limescale with a stable water hardness by adding limescale stabiliser to the tub when you refill it.

Sportster = 140ml
Legend = 160ml
Resort/Portico = 180ml

• 

  View Cart

  Add to cart/Details

  Softub Calcit – Lime stabiliser

  CHF29.90

Clean the filter with a strong water jet (shower head).

For easier filter treatment Estelle filter cleaning device

• 

  View Cart

  Add to cart/Details

  Estelle filter cleaning device – for easier filter treatment

  CHF169.00

• 

  View Cart

  Add to cart/Details

  Filter cleaning brush – to clean and maintain the filter

  CHF39.00

• 

  View Cart

  Add to cart/Details

  Power Blue – filter cleaning and disinfection spray

  CHF22.50

Clean your pool 1-2 times per week, depending on need.

A few days after treatment, use a test strip to check the current chlorine level.

Sportster = 1 spoon
Legend = 2 spoons
Resort/Portico = 3 spoons

• 

  View Cart

  Add to cart/Details

  Softub Cleaning Granules – protection against bacteria

  CHF20.00

• 

  View Cart

  Add to cart/Details

  Scumbug Dir sponge – cleans waterlines in the pool

  CHF11.90

Add the Softcare liquid to the bubbling water.

Shake well beforehand!

Sportster = 140ml
Legend = 160ml
Resort/Portico = 180ml

• 

  View Cart

  Select options/Details

  Softub Water Care Set – refill set for the best care of your Softub

  Ab CHF190.00

• 

  View Cart

  Add to cart/Details

  Softub Water Care Kit – the best care for your Softub

  CHF354.70

Check the pH level of the water weekly.

The optimum pH level is between 7.2 and 7.6.

1 teaspoon of the pH sinker or pH lifter changes the pH level by 0.1 per 1000 l water.

Dependent on the hardness of the water.

• 

  View Cart

  Add to cart/Details

  Softub Test Strips 3 in 1 – for safer water treatment

  CHF19.00

• 

  View Cart

  Add to cart/Details

  Softub pH Plus – Spa pH Increaser

  CHF19.00

• 

  View Cart

  Add to cart/Details

  Softub pH Minus – Spa pH Reducer

  CHF19.00

Dissolve the tablet separately in warm water.

The filter remains in the water solution for up to 24h.

After that thoroughly flush the filter.

• 

  View Cart

  Add to cart/Details

  Softub Filter Cleaner Small – for deeper purity

  CHF20.00

• 

  View Cart

  Add to cart/Details

  Large Softub Filter Cleaner – for deeper purity

  CHF39.00

First clean the inner layer with Waterline and Tile cleaner, ideally with the Ultra Mitt cleaning glove.

After that rub the High Gloss UV Protectant into the outer layer.

Use a dry cloth for this.

• 

  View Cart

  Select options/Details

  Power Blue – High Gloss Ultra / UV Protectant

  Ab CHF22.50

• 

  View Cart

  Select options/Details

  Power Blue – Foil, Waterline and Tilecleaner

  Ab CHF22.50

• 

  View Cart

  Add to cart/Details

  Ultra Mitt cleaning glove – for faster and easier pool cleaning

  CHF19.90

Replace the filter of your Softub whirlpool once per year.

• “Microban” anti-bacteria filter for Softub models from 2009 and later
• Softub filters for year of manufacture 2009 and later
• Softub filters until year of manufacture 2009

• 

  View Cart

  Add to cart/Details

  Softub clip-on filter Microban large from Softub generation 2009

  CHF99.00

• 

  View Cart

  Add to cart/Details

  Softub Snap On Filter – for Softub generations from 2009

  CHF89.00

• 

  View Cart

  Add to cart/Details

  Small Softub Snap On Filter – up to Softub generation 2008

  CHF89.00